Gladiator Pickup Camper EU Size User Guide

2. Remote Control Operation Instructions

Press and hold button IN and OUT simultaneously

2.1 Press and hold the IN and OUT buttons simultaneously for 3 seconds to reset the remote control receiver. The green LED 1 on the remote control will remain on lighting. At this moment, the remote control can be operated normally.

2.2 Press and hold button 6, extend all four jacks simultaneously, and release button 6 to stop running all four jacks simultaneously.

2.3 Press and hold button 5, retract all four jacks simultaneously, and release button 5 to stop running all four jacks simultaneously.

2.4 One click ground touching (leveling) function operation: Press buttons 6 and 5 simultaneously for one second to release, and all four jacks will extend simultaneously. Press any key to stop running. When a certain jack touches the ground, it stops and the other jacks run normally until all jacks touch the ground and stop. If equipped with an tilt sensor, the controller will start the motor sequentially after all the jacks touch the ground, and adjust the extension of each jack until it reaches parallelism. Be careful not to use the one touch leveling function on uneven ground with a slope greater than 2 degree. If the one touch ground (leveling) function is activated and a certain jack cannot be stopped, and the compartment has already tilted, any key needs to be pressed to stop this operation. Then, operate the extension or retraction button of the inclined jack to level it. 2.5 Instructions for single jack extension and retraction control buttons: buttons 1 and 3 can control the extension or retraction of the left front jack. Buttons 2 and 4 can control the extension or retraction of the right front jack. The buttons 7 and 9 can control the extension or retraction of the left rear jack. The buttons 8 and 0 can control the extension or retraction of the left rear jack. When operating the four jacks to extend and retract simultaneously according to “2” and “3” in section

2.6 if one jack is suspended or not touching the ground, the single jack extension or retraction button needs to be operated to adjust the jack to touch the ground!

2.7 When the motor stalling current exceeds 30Amp, the controller stops driving the jacks to extend or retract.

2.8 The controller fuse of jacks is a 30Amp for medium-sized car fuse.

35